In this project it is done only one way, from the Raspberry Pi to the Arduino Mega. If you would like to perform two way communcation check out this link on Serial Communcation Between Raspberry Pi ...

Then I figured out the Pi's assigned address using the router's admin panel, and used "Putty" to connect to Pi over ssh using the IP address. Then I connect the Bluetooth module's rx to pi's tx pin ...

Programming Raspberry Pi as Master using Python. In the Master Raspberry Pi, the angle value of range (0,10,45,90,135,180,135,90,45,10,0) is sent to the RS-485 module via serial port of Pi that sends ...

You will have the list of all attached devices on PI. Now connect the Arduino Uno to Raspberry Pi with USB cable and enter the command again. You can easily identify the UNO attached port from the ...

Part One : Switching ON/OFF the Arduino build in LED Connect the Mate Silver to the Arduino according the the "Arduino_BT_01.jpg" file (see attachments). Power and program the Arduino with the ...

Not only does the Raspberry Pi sport more I/O pins than the Arduino, but it has a good range of communication ports, too. You can effortlessly add internet connectivity to your Raspberry Pi using ...

Now connect the USB cable, the square side of the cable goes to the Arduino UNO while the rectangle side goes to the Raspberry Pi. To upload the code on Arduino UNO, click on Sketch > Upload or ...

Once again in this project i used the Raspberry PI 0 W. The other part of the project is an Arduino Uno connected to the Sparkfun Bluetooth "Mate Silver" module. First thing to do is to configure your ...