Full tutorial A few months ago I found a led driver module composed of a CN5711 IC, a resistor and a variable resistor. From the CN5711 datasheet: General Description: The CN5711 is a current ...

We previously used multiplexing technique in Arduino to interface 4-digit 7-segment display and driving 8x8 LED matrix. Charlieplexing allows you to control N * (N – 1) LEDs, where N is the no of pins ...

This project demonstrates how to connect and control an external LED using an Arduino Uno. It’s a simple and fundamental project that introduces the basics of digital output. In this project, an ...

First, connect the one mega ohm resistor in between Arduino pin 2 and pin 4. Then connect a long wire (copper) to pin 4. This wire acts as an electrode or touch lead, then connect RGB led common ...

I made this Arduino project that allows to turn ON and OFF LEDs using a cheap IR remote control as a preparation for the next big step: disassemble my girlfriend’s chinese LED lamp and replace its ...

In this experiment we are going to use a element called photoresistor. This sensor allows us to interact with the external environment, through intensity of light. The photoresistor is based on light ...

digitalWrite (TXLED, LOW); // set the LED on delay (1000); // wait for a second } TXLED and RXLED hardware connection The Arduino Micro is closely related to the Leonardo, with some small difference.

Circuit and working The circuit diagram of the LED flasher using Arduino is shown in Fig. 1. The circuit is built around Arduino Nano board (Board1), twenty coloured LEDs (LED1 to LED20) and a few ...

Posted in Arduino Hacks Tagged arduino, arduino pro mini, candle, lighting, neopixel, neopixel ring, RGB LED, ws2812b ← Retrotechtacular: There’s More Than One Way To Escape A Submarine ...

Each connection to the Arduino I/O drives an LED anode, while the cathodes are joined between the diodes of each plane and go to lines A, B, C, and D, which will be cycled to logic low. So, as far as ...