The soil moisture sensor module , built around the LM393 comparator, gives an active-low (L) level output when the soil is dry (determined by a pre-setted threshold value). This digital output (wet ...

This is a simple arduino project for a soil moisture sensor that will light up a LED at a certain moisture level. It uses Arduino Duemilanove microcontroller board. Two wires placed in the soil pot ...

This project details the construction of a soil moisture sensor using an Arduino Uno microcontroller. The sensor leverages the electrical conductivity of soil to determine its moisture content. Dry ...

This Arduino sketch demonstrates how to control a relay using a soil moisture sensor and two potentiometers to set the minimum and maximum thresholds for when the relay should turn on or off. The ...

Arduino * 1; moisture sensor * 1; 5v relay module * 1; 6v Mini water pump with small pipe * 1; Connecting wires; 5v battery * 1; Circuit Diagram of the Arduino Automatic irrigation system. The ...

Here using ATMEGA 4809 Arduino nano board and Capacitive Soil Moisture Sensor V2, I am trying to make an Automatic drip-irrigation system. Below is my code which is being used in the project. /* code ...

A low cost Arduino based Automatic Irrigation system using Soil moisture sensor is presented in this paper in which the soil moisture sensor gives it's output depending on the conditions of the soil ...

A soil moisture sensor is the main component in this system which is used to measure the conditions of the soil like whether the soil is dry or wet. For displaying the conditions of the soil, 16×2 LCD ...