3. L298N motor driver board module 4. USB cable A to B 5. Jumper wires pack — M/M 6. Jumper wires pack — M/F The schematic diagram shown in Figure 2 illustrates how L298 H-bridge IC can be connected ...

The schematic diagram of the DIY 3D printed animatronic eye is shown below, and as you can see it's very simple and easy to understand. Although the PCA9685 IC, a 16 Channel 12-Bit PWM Servo Motor ...

The following image shows the circuit diagram for interfacing the flame sensor module with Arduino. Connections are pretty simple and only require three wires. Connect the VCC and GND of the module to ...

Density-Based Traffic Light Controller using Arduino Overview This project implements a density-based traffic light controller using an Arduino microcontroller. The system adjusts the traffic light ...

PlatformIO repository to develop the microcontroller software with the Micro-ROS framework for the Robotic Neck project produced for the Design of Robotic Systems (Capston) course. This repository ...