In this quick Arduino tutorial I will explain how you can control a relay using the Arduino Board, one 1K and one 10K resistors, 1 BC547 transistor, one 6V or 12V relay, one 1N4007 diode and a 12V fan ...

This project demonstrates how to interface a relay module with an Arduino to control high-voltage appliances safely. The setup involves using a relay as a switch, allowing the Arduino to control ...

This project demonstrates how to create an anti-sleep alarm system for drivers using an Arduino Nano and a Relay Module. The system detects signs of drowsiness or fatigue in the driver and triggers an ...

3. L298N motor driver board module. 4. USB cable A to B. 5. Jumper wires pack — M/M. 6. Jumper wires pack — M/F. The schematic diagram shown in Figure 2 illustrates how L298 H-bridge IC can be ...

IN1 & IN2 control Motor A, while IN3 & IN4 control Motor B. The MX1508 includes built-in pull-down resistors on all inputs, so if left unconnected, the pins default to a LOW state. When both inputs ...

Code for Interfacing the TMC2208 Module with Arduino UNO. As we are not using UART to control the motor, the code will look simpler. Here, we are going to perform functions like rotating the motor at ...

If so, remember to connect the VCC pin to 5V of the Arduino board to enable the control input pins IN1 and IN2. Also note at this point that, if you want perfect galvanic-isolation, do not link ...

Tip: learn how to power light bulbs using Arduino with a relay module. What You’ll Need. If you’re ready to get started, you’ll need these items to get this project off the ground. Hardware. HW-479 ...