This is a simple arduino project for a soil moisture sensor that will light up a LED at a certain moisture level. It uses Arduino Duemilanove microcontroller board. Two wires placed in the soil pot ...

The hardware is consists of an Arduino microcontroller (here an Arduino Uno R3) and a pre-wired soil moisture sensor module. The soil moisture sensor module , built around the LM393 comparator, gives ...

This project details the construction of a soil moisture sensor using an Arduino Uno microcontroller. The sensor leverages the electrical conductivity of soil to determine its moisture content. Dry ...

Soil Moisture Monitoring with Arduino – Circuit Diagram Fig. 3 shows the physical connection of the system, while Fig. 4 provides the schematic. In both diagrams, the sensor’s output signal pin is ...

Simple Arduino Library for the WisBlock I2C Soil Moisture Sensor version from RAKwireless which is ready to use with I2C. In Arduino IDE open Sketch->Include Library->Manage Libraries then search for ...

I'd probably use one module to run 5 or 6 sensors, conformal coated and buried. I'll do some shallow trenching for wires, and mark the sensor locations somehow so I don't mow over them.

Monitoring moisture of soil using low cost homemade Soil moisture sensor and Arduino UNO Abstract: Persistent increase in population of world is demanding more and more supply of food. Hence there is ...

For now, just moisture. However, there's no reason I can't add more sensors if I want to. pH isn't something that's going to be changing rapidly. I can check that annually and probably be fine.