The code compiles on Arduino IDE 1.8.x or higher with board set to Arduino Uno. The transmitter code is in mtx (master mcu) and stx (slave mcu) folders. The receiver mcu code is in the rx folder. No ...

Unfortunately you won’t be able to bind your existing RC vehicles to this radio, but since the receiver side is no more complicated than another Arduino Nano and NRF24 module, it shouldn’t be ...

Read on to see how. Signals from the Arduino can be sent to the transmitter as a result of this interface. The arduino signal is mixed with the manual input and the resulting signal is received by the ...

Build a 3D printed Arduino-based pistol-grip radio transmitter for RC cars, boats, etc. 8 channels of control inputs, 1KM maximum range, 48-hour battery life. Uses parts including Arduino Nano, ...

Long-range RC transmitter “I started using Bluetooth devices like the HC-05 modules, but I found that these sometimes randomly disconnected. Since then I’ve been using the NRF24L01 modules ...

In this project, we will build a remote-controlled Arduino Air-Boat that can be controlled wirelessly using the 433 MHz RF Radio Modules.We will control this boat using a homemade remote control by ...

The PCB schematic is for the Arduino 8-channel NRF24L01 receiver and is the main part of the head tracker project, serving as the backbone controller for both the transmitter and receiver sides. By ...

Connect the module's VCC pin to the 5V pin of the Arduino and connect the GND pin of the module to ground. The data pin should be connected to the pin D12 of the Arduino. Here at RF Transmitter side, ...

The code compiles on Arduino IDE 1.8.x or higher with board set to Arduino Uno. The transmitter code is in mtx (master mcu) and stx (slave mcu) folders. The receiver mcu code is in the rx folder. No ...