I made this Arduino project that allows to turn ON and OFF LEDs using a cheap IR remote control as a preparation for the next big step: disassemble my girlfriend’s chinese LED lamp and replace its ...

This is a simple 0 to 9 counter circuit constructed using Arduino! Here, a common cathode 7-segment LED display is connected to Arduino for displaying the digits. The code (Arduino sketch) allows push ...

Like almost all Arduinos, has a built-in led – the green one on the left in the photo. And it has a pair of yellow leds – called TX and RX – to indicate traffic on the serial bus. Except, on the Micro ...

To actually power and control the entire circuit, [Martyn] used an Arduino loaded up with a program based LedControl library makes programming the spedometer a snap.

When you read “Arduino wristwatch”, you fall into the trap of envisioning an Arduino UNO clumsily strapped to someone’s wrist. [Marijo Blažević’s] creation is much more poli… ...

The mod works using a MAX7219 chip and Arduino Uno ATmega328 board, which control the two 8×8 LED matrixes making up the eyes. Each matrix is wired up to the MAX2719 chip–expect a lot of cables ...

Arduino has shrunk the UNO R4 with the Arduino Nano R4 board equipped with the same 48 MHz Renesas RA4M1 32-bit Arm ...

2. You should see Done Uploading and Transfer complete messages when your sketch has uploaded. 3. The DS2 LED on your board should now blink on or off every second.

The UDOO has the same pins as the Arduino DUE, as well as the DUE's ARM SAM3X processor, which is dedicated to the GPIO pins. Android 4.0.4 or Linux (Ubuntu 11.10) runs on a second processor, a ...

As described on the Hackster Profar blog, as features go, the Shield sports a reset switch, power LED, Arduino pin 13 LED, Pi GPIO pin 13 LED, headers for full Arduino pin access, and ICSP header for ...