PWM pins work the same way across all Arduino boards, so you don't need to go out of your way to buy a Mega if you already have a board supporting PWM. On the Uno, Nano, and Mini, the PWM pins are ...

use spi interface to transfer code, on mega use the icsp connector some sites mention to put a 10us capacitor between gnd and reset to ovoid a reset after the serial communication has been completed ...

Change the IP address of the Arduino in the Mach4ModbusW5500.ino sketch to conform to your network. For example, if your network subnet is 192.168.1.X then change the IP address to something like ...

[Andy] didn’t want to use up 24 pins on his Arduino, so he used a latch to multiplex the lowest 8 address lines and the data lines together. With the 512KB RAM expansion installed, the Mega is ...

The Ultimate Arduino Mega 2560 Hardware Manual is from the same author and the table of contents is about the same as in the first book, but of course tailored to the Mega 2560 board. One difference ...

Step 1: Configuring Arduino Uno as an ISP: Since ATtiny85 is just a microcontroller, it requires an ISP (In-System Programming) to be programmed. So to program the ATtiny85, we need to first configure ...

Arduino GIGA R1 WiFi board brings the STM32H7 dual-core Cortex-M7/M4 microcontroller found in the Portenta H7 boards to the larger Arduino Mega/Due form factor with up to 76 GPIO pins. As its name ...