Add your application code to the setup and main loop. The value of the incoming PWM signal is avaliable to you as the variable 'pwm' and ranges from 0 to 255, corresponding to a pwm of 0 to 100%. pwm ...

A few months ago, [Julian Ilett] found a problem using the Arduino library for PWM. Recently, he revisited the issue and used his own PWM code to fix the problem. You can watch the video below.

The Atmega 328P chip in the Arduino Uno has three PWM timers (known as Timer 0, Timer 1, and Timer 2) controlling six PWM outputs. Each of the timers has a prescaler that generates the timer clock by ...

input.txt in this file you paste or write values read by arduino ADC they should be in range of 0, 1024; pwm.txt this is the file in which you put values for translate_to_pwm.py they should be in ...

I routed the first PWM channel out to J3 on the edge of the iCEStick so I could connect a scope probe to look at the real results. Below you’ll see the output at 50% (40 hex) and 12.5% (10 hex).

Arduino Gemma from Adafruit is also based on the ATtiny85, and PB0 and PB1 appear to be accessible. This board has a USB connector for programming and a voltage regulator. This board, which I am ...

For example, Figure 1’s circuit illustrates using PWM to digitally set the analog gain of a versatile, robust, high (1 MΩ) input impedance, buffered output, DC input stage over a ~16 bit = 65280:1 = ...