15 thoughts on “ Arduino Controlled Dahlander Motor Switch ” danieljlouw says: April 2, 2014 at 11:15 pm I cannot ... I suspect he WANTED to use an Arduino. Report comment. Reply.

Switch S1 is the traditional reset switch as found in the Arduino board. Here, ports PD2, PD4 and PD7 of IC1 (D2, D4, D7 of Arduino) are configured as input ports,and ports PB0, PB4 and PB5 (D8, D12, ...

That’s because brushless DC motors require carefully timed signals used in a process called Electronic Speed Control (ESC). [Fileark] built and ESC using an Arduino and has a couple of posts ...

Because students are using it, it needs to be short-circuit-proof – no possibility that a mix-up in control signals can cause the drive to short out the rails (see DANGER, right). BTW, don’t use these ...