Regular readers will know of my interest in (obsession with?) the temperature and humidity here in the office.Today I took this to a whole new level with this: That’s an Arduino wired up to a DHT22 ...

This Project is about Arduino Based Temperature and Humidity sensor using NodeMCU- ESP8266 WiFi module which connect to a WiFi network as well as interact with the Internet and DHT22 sensor which is ...

"Arduino code to read and display humidity and temperature data using DHT11/DHT22 sensors." #include <DHT.h> #define DHTPIN A0 // Pin where the DHT11 is connected #define DHTTYPE DHT11 // DHT 11 ...

In this Arduino Uno based project we are going to measure ambient temperature and humidity and display it on a 16x2 LCD screen. A combined temperature and himidity sensor DHT11 is used with Arduino ...

In the loop function, we have created an event and using this event the temperature and humidity data is read from the DHT11 sensor. Then this value is printed to the serial monitor. The below GIF ...

The Anavi Thermometer Development board is fully compatible with the Arduino IDE, ... It comes with a built-in DHT22/AM2302 temperature and humidity sensor and has slots for a mini OLED ...

Here are the steps I took to install Node-RED on my Raspberry Pi B, and then to wire it up to a DHT22 humidity and temperature sensor to log the conditions in my office. It’s based on my work last ...

Arduino Nicla Sense Env is a new sensor module with temperature, humidity, and gas (TVOC, NO2, O3) sensing that follows the launch of the Arduino Nicla Sense ME (Motion & Environment) module over ...

Aim: The objective of this work is to control load at home using Arduino IDE with DHT11 sensor and comparing its temperature performance with microcontroller device. Materials and Methods: In this ...