Configuring XBee Modules using XCTU. As we have learnt in previous tutorials that the XBee module can act as a Coordinator, Router or an End device but it need to be configured to work in desired mode ...

The hardware is consists of an Arduino microcontroller (here an Arduino Uno R3) and a pre-wired soil moisture sensor module. The soil moisture sensor module , built around the LM393 comparator, gives ...

30 thoughts on “ Retro-fit Old Radio With Arduino And FM Module ” Galane says: July 2, 2015 at 1:09 am Where’s the Ard… oh, right. Report comment. Reply. lwatcdr says: ...

The module I purchased is from Digikey for $4.25 Part number ‎1597-102110419-ND‎, manufactured by Seeed Technology Co., Ltd. It can be purchased on ebay, AliExpress, and of course the Seed Studio ...

So in this tutorial, we decided to interface the SD Card module with Arduino and we will let you know all the details. So without further ado let's get right into it. Micro SD Card Module Pinout. The ...

The relay module will need 5V from Arduino to power up and will get input from four different digital pins of the Arduino. Now let’s connect the relay module to your home appliance. Take the positive ...

The usual method is to use the Arduino’s analog pins to send PWM signals to the module. This lets you mix each color, giving you full control over the RGB LED. Meanwhile, the other (digital) option is ...

Try “Arduino in 555 timer form-factor” and you have an article on using DIP-8 AVRs. Piunora opens up both the 3v3 on 0.1″ pitch and USB world of MCUs or a non-CM pi, and PCIe from the ...

The transmitter comprises Arduino Nano (Board1), Yoda module (YM1), Yoda adaptor (YA1), two resistors (R1 and R2), and two on/off switches (S1 and S2), as shown in Fig. 2. Fig. 2: Transmitter circuit.

All the pins of this sensor module are digital, except VCC and Ground.-> GND is the ground pin of the micro sd card module and it should be connected to the ground pin of the Arduino.-> VCC is the ...