Using an Arduino, without using the Arduino ISP and without having to flash a bootloader on the ATtiny. An binary image of the ATtiny program will be created and flashed with an arduino using SPI ...

The Arduino ISP communicates using the Serial Peripheral Interface (SPI) protocol for programming AVR microcontrollers. SPI communication uses 4 logic signals: MOSI, MISO, SCLK, and SS. Other than I 2 ...

Setup is simple enough, only requiring a connection between the ‘328 ISP header and the pins on the ’16u2 header. ... I use an Arduino and as far as I understand your post, you hate me.

This project implements an Atmel In System Programmer (ISP) programmer using only a low cost (≈$5-$17) Pro Micro (Sparkfun DEV-12640 or equivalent clone) (or Leonardo) module with an ATMega32U4 ...

On the other hand if you already have the Arduino, fetch the avr.isp.03 firmware and AVRdude. Then program a device, for example an ATtiny13 using the Ardunio as the programmer.

Your Arduino UNO board (here used as a programmer) If you go through the Arduino IDE you can see an example sketch called “Arduino as ISP”. If you upload this code to your Arduino, it will basically ...

6. Serial Port Already in Use . This is probably one of the easiest errors to resolve. It usually occurs when you try to upload code to an Arduino while the serial monitor is opened (this is no longer ...