DVD drive to make mini CNC plotter machien To make Arduino based mini CNC plotter machine obviously we need two scrap DVD drive. I purchased this drive from local computer repairing shop in less then ...

Arduino pen plotter and laser engraver 10:47 am October 31, 2019 By Julian Horsey ...

Arduino UNO connection diagram with controller and motors: The version of Arduino used to create the project is the UNO board, with an Atmega 382p microcontroller, 32 kB Flash memory, 2 kB RAM, 14 ...

Being only ten at the time I was unable to build the thing and, now that I’m 40, I still can’t fathom how to build this DIY CNC plotter out of a DVD player and some Arduino gear.

My CNC is built from 2 DC servo motors for X, Y axis and 1 stepper motor for Z axis.” Watch this video on YouTube. “Motor voltage: 24 VDC, 38 VDC (E-type).

To produce an Arduino based two dimensional plotter mechanical parts were collected, assembled and targeted mechanism was created. After the integration of the stabilizers into the mechanism that was ...

A servo motor is along for the ride, ... 23 thoughts on “ Mug Plotter Based On The Egg-Bot ” dave says: ... ditch the sharpie for a laser…etch some glasses. Report comment. Reply.

2. Connect one of the servo’s yellow signal wires directly to Arduino pin 9, and the other servo’s signal wire directly to Arduino pin 10, as shown in the circuit diagram in Figure 10-4. 3.