This project demonstrates how to set up and control a self radio receptor using the TEA5767 Radio module with an Arduino. The frequency can be adjusted through serial commands. Once the code is ...

Still in the mess-o-wires phase, the radio is centered around an ATmega328 talking to a TEA5767 FM radio module over I²C. Tuning is accomplished by a 10-turn vernier pot with an analog meter for ...

Arduino_FM_Radio uses a TEA5767 module to recieve signals from fm stations (library: TEA57587.h) amplifier module (hardware) to amplify sound signals from TEA5767 as on-board amplifier in the module ...

This was done as pin 9 had to be used for the radio module. To connect the radio module's SPI data lines, we'll use some more of this 30-gauge wire for CE, CSN, MOSI, MISO, and SCK. We'll additionally ...

The friend’s radio didn’t come with a frequency display, and buying the add-on would cost more than the radio did. So [Todd] has set out to build an Arduino frequency counter for a Kenwood TS ...

Two years after launching the Curie-powered Arduino 101 maker board, Intel is calling it quits on the hardware. The chipmaker has announced the end-of-life for its Curie Module, which launched in ...

The 4G LTE module works with Arduino Pro carrier boards featuring a mini PCIe connector such as the Max Carrier and the new Mid Carrier which we will be covering below. More information can be found ...