Pin 2 on the Arduino schematic is really GPIO2 on the NINA, therefore it should not be labeled GPIO34. This is confirmed by the fact that the pin numbering on the Arduino schematic matches the pin ...

The Arduino Nano was used for this demonstration as it has 5 volt GPIO pins and the lasers are 5 volt as well - so easy to wire up. Also, the lasers consume about 10mw each, which is just under the ...

All Arduino boards have this pin, and it's connected to the built-in voltage regulator that makes sure your board receives a stable supply. For the Nano, the VIN pin is found on Pin 30 (although ...

The Arduino Nano and Uno are equipped with very similar processors (the chip that essentially serves as the brain of the board). The Nano features an ATmega328, while the Uno sports an ATmega328P.