The hardware is consists of an Arduino microcontroller (here an Arduino Uno R3) and a pre-wired soil moisture sensor module. The soil moisture sensor module , built around the LM393 comparator, gives ...

This is a simple arduino project for a soil moisture sensor that will light up a LED at a certain moisture level. It uses Arduino Duemilanove microcontroller board. Two wires placed in the soil pot ...

Using an Arduino, a moisture sensor, an LED matrix, and a few other parts, dr.mcc's build monitors the moisture level in a pot of soil and then lets you know when the plant needs water by ...

The Sketch The sketch first defines Arduino pin A0 so that it reads the moisture sensor value. It then defines Arduino pin 11 as output for the buzzer, and pin 13 as output for the LED. Use the Serial ...

I'm planning to have a "spider" of moisture sensors off one Arduino - 5 or 6 coming off one box. Again, I doubt you need continuous monitoring even with multiple sensors.

The calibration process involved comparing data from capacitive sensors with soil moisture content measured continuously by the volumetric water content (VWC) method. The results showed that sensor ...