To use the EEPROM programmer you will need to construct the hardware, flash the Arduino with the eeprom_programmer software and install the CLI.

Details of interface construction and the mapping of Arduino pins to GPIB control signals and data bus are explained in the "Building an AR488 GPIB Interface" section of the AR488 Manual. Commands ...

Since the ST24C04 512-byte device in question has an I 2 C bus it’s a straightforward add-on for an Arduino Mega, so we’re shown the wiring for which only a couple of pull-down resistors are ...

In Arduino Uno, the EEPROM space can store up to 1024 bytes. A single byte can store 8 bits of information, and 8 bits can store a number from 0 to 255. In the Arduino IDE versions prior to 1.6.2 you ...

This is a wiring diagram that [Soranne] put together when developing a method of programming PIC microcontrollers using an Arduino board. You can see that he takes care of the 12V issue by connecti… ...

Brain-Computer Interface (BCI) is the modern approach to the construction of the Human-Machine Interface (HMI) that interconnects human brain and the machine and allows to send commands to the machine ...

ISRO Satellite Centre (ISAC) is the lead centre for development and operationalisation of communication, remote sensing and interplanetary missions. These satellites contain highly advanced embedded ...

Meet the Arduino Compatible RFID Reader Module. It can hold card data for up to five cards, takes seconds to program, and holds card data in EEPROM memory, which means that the cards are saved ...