7 thoughts on “ Arduino-based Temp Control Via SMS ” Jimbo says: September 25, 2013 at 7:14 pm Must be nice! Report comment. Reply. lwatcdr says: September 26, 2013 at 8:20 am I think ...

This project demonstrates a temperature-based fan control system using an Arduino Uno. The system reads ambient temperature via a DHT11 sensor and adjusts the speed of a 12V exhaust fan accordingly ...

In this circuit LM35’s output is connected to the Arduino’s A0 pin, which converts the available output voltage value to a float value of temperature, and then, displays it on the LCD screen. The 10K ...

The temperature sensor is built using an NTC 10k thermistor, which changes its resistance in response to changes in temperature. The resistance of the thermistor is measured using the Arduino's analog ...

In our case fanSpeed will have a value of 32 at tempMin and 255 at tempMax. These values are used to control the speed of the fan using PWM and the analogWrite(). The fanLCD re-maps the temp to allow ...

This paper presents the development of a Arduino based Proportional-Integral-Derivative (PID) temperature control system using an Arduino UNO, R-type thermocouple, and solid-state relay (SSR) within a ...