Using an Arduino Nano ... it defines the rate at which the buzzer and LED can blink. Initially, it was set down to zero. But while executing it, get updated based on the distance variable. /* ===== ...

Reusing the LM4041 voltage regulator to create a precision current source by leveraging the CATHODE pin as a sense pin.

If you’re breathing in nasty VOCs or dust, surely a little blinking LED isn’t enough to express your displeasure with the current situation. Luckily, [Tobias Stanzel] has created the AqMood to ...

First of all, we’d like to give a big shout-out to [Afrotechmods]! After a long hiatus, he has returned to YouTube with an awesome new video all about op-amp characteristics, looking at the ...

This project demonstrates how to blink an LED on and off using an Arduino UNO. It is a beginner-friendly project to get started with Arduino programming, basic electronics, and controlling outputs ...

Blink-182 bassist Mark Hoppus says that the band breaking up led him to having suicidal thoughts. Blink-182 first split in 2005 and then again in 2014. In his new memoir Fahrenheit 182, Mark Hoppus ...

On the internet information can be found how to use USB to serial chips like a FT232 or CH340 as a programmer by connecting Tx and Rx by a resistor or diode ... The number of LEDs that blink twice ...

This project demonstrates an interrupt-based embedded system built using the Arduino Nano 33 IoT, a BH1750 light sensor, and a slide switch. The built-in LED is controlled through external ...