Arduino DMX. There’s only a single piece of cheap hardware needed to add to an Arduino-compatible design to allow it to handle DMX – just an RS485 transceiver chip. There are many of these around us, ...

The MIDI-DMX Bridge is an Arduino-based hardware and software solution that converts MIDI Continuous Controller signals to DMX commands. The project consists of a hardware schematic and PCB designed ...

In a recent post we interfaced a small DMX RGB LED Par Light with an Arduino Uno through a MAX485 module. In this post we will learn how to work with a compact USB to RS-485 Converter Module. This ...

DMX.write(A, B) will give a DMX address A the value B (between 0 and 255) Once the arduino is working, you need to add a drive chip to convert the ardiuno 0 to 5 volt signal into a -2,5v to 2,5v ...

Spread the loveSchematic drawing software for Arduino, Raspberry Pi, and other Single Board Computers (SBCs) is essential to developing electronics projects. When it comes to creating circuits on a ...

The prototype stack is pretty straightforward - an Arduino, a DMX shield, and a MIDI shield, stacked nicely. Oh, and a USB to MIDI converter, and a DMX output connector, and a hub because there ...

The schematic is quite basic, and based on the Entec open DMX. However, an isolated RS-485 tranciever of Analog devices (ADM2483BRWZ) was chosen in combination with a circuit monitor (ADM809SARTZ). An ...

Network to enable or disable a controller using processing of signals has been emerging as a viable solution to many innovative applications in the industry such as; remote control technology, ...