Takes the outputs of 2 2 pole tilt switches and displays their current state(s) on 4 LEDs. Each tilt switch covers 2 cardinal directions, and is named as such in the code. In other words, one switch ...

In the Arduino IDE, by using digitalRead() with the pin connected to the tilt switch, you will get either a HIGH or LOW (1 or 0) signal. ... You will also need to configure which pins you are using ...

The type SW-520D is a commonly available roller-ball type tilt sensor consists of two conductive elements (poles) and a conductive free mass (rolling ball), encapsulated in the same case. When the ...

LED is connected with the PIN 2 of the Arduino UNO with 220-ohm resistor to limit the current to a safe value. And, the buzzer is directly connected to the PIN 3 of the Arduino UNO. Tilt Sensor . This ...

3. Download the final code and open it in Arduino IDE. 4. Put the values for ‘A_max’ and ‘A_min’ in the final code as shown in Fig. 7. 5. Program Arduino again with this new code and the system is ...

A detailed wiring diagram is shown below as a quick reference for the hardware setup program. (wiring diagram) Remember to attach the TILT-Servo to SV-TILT connector, and PAN-Servo to SV-PAN connector ...