Ensure you have the leanios-ot-api-cpp library installed in your Arduino IDE. Follow the steps below to add the library to your Arduino IDE: Download the LeanIOS-OT-API-CPP library as a zip file .

The CHx01 sensor module must be connected with a flex to the J11 connector (Device 0 port). Note: On CHx01 sensor, the interrupt is a 1v8 bidirectional signal going through a level shifter (present on ...

Connections are pretty simple and only a few wires. Connect the VCC and GND of the sensor to the 5V and GND pins of the Arduino. Then connect the output to the Arduino’s D2 pin. Here's how the ...

An Arduino IDE project using the Indusboard can send sensor data over Web Serial to a web browser, allowing real-time monitoring and analysis.. By creating a web page with the Web Serial API, it can ...

Rutronik Adapter Board RAB7 is an open-source hardware Arduino shield designed for AI-powered Sensor Fusion with seven environmental and inertial sensors from Bosch, Infineon, and Sensirion. The ...

If you have an Arduino that can act as a keyboard for a PC, the code almost writes itself. [Rootsaid] uses a specific library for the PAJ7620 and another — Nicohood — for sending media keys.

That’s right, these parking sensors are powered by an Arduino board, and the only extra components that were used in the project are a HC SR04 ultrasonic sensor, an active buzzer, and jumper wires.