The Pinout of a Micro SD Card Module is shown below: GND is the ground pin of the micro sd card module and it should be connected to the ground pin of the Arduino. VCC is the power supply pin of the ...

-> GND is the ground pin of the micro sd card module and it should be connected to the ground pin of the Arduino.-> VCC is the power supply pin of the micro sd card module that can be connected to 5V ...

It turned out the SDIO mode on [Severin]’s card was broken, but accessing it with an Arduino and SPI mode worked. There was finally hope to get files off this damaged card.

Module for accessing and controlling an SD Card operating in SPI mode. Note on Portability: This SD Card module is originally intended to work with the SPI port on an ATMega1280 AVR microcontroller.

Here in this project, you can either use 1 Arduino or 2 Arduino. if you are using 1 Arduino then the SPI and I2C components connect to the Arduino SPI and I2C pins as in the circuit diagram. You can ...