Here is an artistic Arduino project for the fun-minded. The circuit is an Arduino RGB LED controller running on a sweet ‘n’ simple code,but with a little hardware surprise outside the Arduino board.

Check out the examples folder for basic use examples. ###################################### #The following methods are available:# ###################################### .red .green .blue .custom ...

I'm an Arduino newb, so go easy on me. :) I have an Arduino Uno with a Grove Base Shield and a Grove LED Strip Driver. I have Superlight strip LEDs. I'm using some of the example code and it seems ...

This program uses three potentiometers for RGB control and displays the resulting color on an RGB LED. - fyemane/Arduino-Control-RGB-LED ...

But first, let’s look at the circuitry. The schematic diagram shown in Figure 3 is a model of simplicity. The three RGB LEDs are switched on and off by modest driver transistors under the control of ...

Wire the RGB LED in the PMW pins 9,10 and 11 of the Arduino. Connect the pushbutton to pin 7 . Connect the three potentiomete2 into pin A0, A1 and A3 respectively Add a 10Kilo-Ohms resistor to the ...

Infineon's RGB LED Lighting Shield is one two of Arduino-based evaluation boards created to showcase the capabilities of its ARM-based XMC1000 MCUs in lighting and motor control applications. Unlike ...