If you have not already, connect the Soft Power Switch's power, OFF, and PUSH to your Arduino's GPIO pins. In this case, we used the SparkFun IoT RedBoard - ESP32 Development Board. Depending on your ...

After making this power outlet box, you can use any sensor with your Arduino to switch on or off the power supplied to the outlet. Here the presenter has used a DHT11 humidity and temperature sensor ...

This is the code for the "Wireless Power Switch with Arduino & the CC3000 WiFi Chip" article on the Open Home Automation website. This project is about building a wireless power switch & energy ...

After making this power outlet box, you can use any sensor with your Arduino to switch on or off the power supplied to the outlet. Here the author has used a DHT11 humidity and temperature sensor to ...

When power is turned on, ... When reed switch is opened, pin 2 of Arduino goes high with the help of the pull-up resistor R2, and the alert signal is available through the piezo-speaker PZ1 (not an ...

Infineon has developed an Arduino shield to demonstrate the potential of its 24V Profet protected power switches. Called the Protected Switch Shield, it is also compatible with the firm’s own XMC ...

This project is based on the different types of sensors in the Proteus that get the power when the Proteus simulation is started. ... It is also the digital sensor and I have used a toggle switch to ...

They both take their power from the Arduino main board. The distance sensor output is fed into pin 2 on the Arduino and the FET driver input is taken from pin 9.