Nell’articolo di oggi vedremo come realizzare una vera e propria radio su cui ascoltare le varie stazioni radio utilizzando una board Arduino Nano, un TEA5767, due bottoni, un display e delle casse.

Instead, he drew up a simple schematic that used an Arduino Nano, an FM radio module based on the TEA5767, and an audio amplifier based on the LM386.

Because some hardware setup is required to build up a functioning radio, an Arduino can be used to supply the voltage and control the radio chip. The 3.3-V power can be taken from the Arduino’s ...

The friend’s radio didn’t come with a frequency display, and buying the add-on would cost more than the radio did. So [Todd] has set out to build an Arduino frequency counter for a Kenwood TS ...

Arduino + Radio = Fun. Though primarily focused on the Arduino Nano, the projects outlined in this publication are fully compatible with the Arduino Uno.The book kicks off with a chapter on the ...

Read on to see how. Signals from the Arduino can be sent to the transmitter as a result of this interface. The arduino signal is mixed with the manual input and the resulting signal is received by the ...

Arduino FM Receiver Circuit Diagram. We used two potentiometers for tuning the FM band and controlling the volume of the audio amplifier. To change the volume you can either vary the pot, which is ...

EL modulo nRF24L01 es un transreceptor radio muy extendido entre dispositivos de comunicación por radio de cualquier tipo (drones, ratones, teclados, ...) Este modulo utiliza un protocolo de ...

This project mixes the commands sent from the Arduino to the transmitter with the manual input by connecting an Arduino to a Radio Control Transmitter. A trainer cable for the RC transmitter had to be ...

S7: OK or ENTER switch for radio (need to press each time while changing the channel of radio) How to adjust Alarm Time. Push S4 to switch on alarm mode; Press and hold S3 and then press S2 to enter ...