Arduino UNO Board with a joystick and 4 LEDs, control the movement of the joystick (up, down, left, right) to light up corresponding LEDs. The project code that includes the optional joystick button ...

In my case I have used only 3 x 330Ω resistors, 3 leds and a TSOP4838 IR receiver module. You must check the datasheet before use the IR module to see which pins connect to the power supply and which ...

4 thoughts on “ 1D LED PONG, Arduino-Style ” Joshua says: December 15, 2023 at 10:40 pm That’s a fine idea for a game. Well ... We used TTL chips on a breadboard.

STEMTera Breadboard is specifically designed to solve common issues using Arduino with a breadboard especially in the lab or classroom. There were 3 main objectives I wanted to focus on when ...

So the TX and RX leds are driven by a couple of pins on the ATmega32U4 (see a comment on the hardware connection below) to make it look like they are on the serial bus. They were not intended to be ...

Wi-Fi Setup: o Connect the ESP32 to a Wi-Fi network by entering your credentials. LED Control: o The BLYNK_WRITE function listens to changes in the virtual pin (V0) from the Blynk app. o The LED state ...