After recording a slow-motion video at 240fps it turned out there was a delay when using the LED strip, so instead of turning the LED strip on every 12.5ms and off 12.5 ms the current code was ...

Presented here is the circuit that drives twenty LEDs in a random manner. LED flashers and sequencers are used in decorative lights to give pretty colour combinations by glowing LEDs in random or ...

The Arduino board is constructed with the microchip Atmega328. However, to program the chip on an Arduino board, one usually programs it with the Arduino IDE using the Arduino framework. This can be ...

Circuit Diagram and Working Explanation Here we are going to write a program to blink an LED for every 500ms. In arduino uno, a LED will be already designed at the pin13, but we are not going to use ...

Fig. 2: Circuit diagram for the flashing light The nine output pins of the Uno board are connected to the nine LEDs, one each, which switch on and switch off at predefined interval. As the high state ...

Here is an artistic Arduino project for the fun-minded. The circuit is an Arduino RGB LED controller running on a sweet ‘n’ simple code,but with a little hardware surprise outside the Arduino board.

This water sculpture can stop drops of water in mid-air. This is accomplished by flashing LEDs to illuminate the droplets at just the right time. But it’s not limited to blinky lights alone. … ...

In this project we are going to design an 8x8 LED matrix display, for that we are going to interface an 8x8 LED matrix module with Arduino Uno. An 8x8 LED matrix contains 64 LEDs (Light Emitting ...

Arduino Sketch Code /* * Arduino Camping Light * Camping Light with a single push button switch to control the light output between off, dim, medium, and high brightness * Test Configuration: MCU: ...