News

To use a dark sensor instead, connect LM358 ‘s pin 7 of to one of Arduino’s digital I/O pins. As a dark sensor, the circuit will output as HIGH when it’s dark and a LOW when there’s light. The output ...
Connect the A0 pin of the Arduino to the same column where the LDR and resistor is connected (Since the LDR gives out an analog voltage, it is connected to the analog input pin on the Arduino. The ...
It’s like Dark and light Detector circuit but this time we are using Arduino to get more control over light. In this circuit, we are making a Light Sensor using LDR with Arduino to control a bulb/CFL ...
Learn to create a simple light-following robot using Arduino, LDR sensors, and an MX1508 motor driver. This beginner-friendly project includes ... using has three pins: VCC, GND, and DO. This module ...
The circuit of Arduino-based shadow alarm is shown in Fig. 1. It consists of an Arduino board, power supply, light-dependent resistor (LDR) sensor, buzzer, relay driver and a few other components.
Connect the A0 pin of the Arduino to the same column where the LDR and resistor is connected (Since the LDR gives out an analog voltage, it is connected to the analog input pin on the Arduino. The ...