This is a simple Arduino library for use specifically with SparkFun Electronics' Color LCD Shield. It'll no doubt work with other incarnations of LCD breakouts and what not, you just might have to do ...

This product is open source!. The code is beerware; if you see me (or any other SparkFun employee) at the local, and you've found our code helpful, please buy us a round!. Please use, reuse, and ...

It consumes 1µA current and powered by 3.3V so be careful and do not connect it with 5V pin. ... GND of APDS9960 are connected to 3.3V and GND of Arduino. The interrupt pin (INT) of APDS9960 is ...

Ensure that the backpack pins are straight and fit in the LCD module, then solder in the first pin while keeping the backpack in the same plane with the LCD. Once you have finished the soldering work ...

Oh, I so wish that (a) I lived in (or near) Boulder, Colorado and (b) I was a high school kid again, because then I could attend the forthcoming “Introduction to Arduino” Workshop that's to be hosted ...

Third-party Raspberry Pi RP2040 boards announced with products from Arduino, Adafruit, Sparkfun and Pimoroni, as well as ... but instead Arduino and Raspberry Pi joined hands to design Arduino Nano ...

C.1 Arduino Code. The Arduino code is available in the below code block. Just connect your Arduino-Nano to the computer and compile/upload the code. Code.ino. C.2 Testing. The lower limit of the ...

SparkFun has just launched the “IoT RedBoard – RP2350” and “IoT RedBoard – ESP32” boards with Arduino UNO R4 form factor based on respectively Raspberry Pi RP2350B + RM2 wireless module and ...