34 thoughts on “ Arduino Converts Serial To Parallel: The Paralleloslam ” ... Paralleloslam then flips its GPIO pins, fires off a byte down the parallel port, and gets the next one in.

41 thoughts on “ Dual Core Arduino For More Pins ” Mike Rogers says: August 31, 2012 at 4:54 am I2C master and slave. Nicely ... There’s no parallel execution going on here, ...

Now attach a breadboard on one side of the wooden board and fix the Arduino nano in the breadboard. Connect the piezo buzzer and an LED in the parallel configuration on the breadboard. Connect their ...

For such cases we use serial to parallel converter chips or shift register. A shift register chip takes data from UNO board serially and gives output in 8 bit parallel configuration. Components ...

GY-271 sensor have four pins. VCC – power supply for module 3.3V to 6V DC. GND – Module ground pin. SCL – I2C clock pin. SDA – I2C data pin. DRDY – Data ready this pin will generate a interrupt when ...

It represents the digital pin on the Arduino to which the PIR sensor is connected. In this example, the PIR sensor is connected to digital pin 5. void setup() {This line marks the beginning of the ...

I come up with a solution in the form of an Arduino-based paper cutter. This project follows from a recent one where he assembled an automatic wire cutting machine that can handle up to four different ...

It transpires that folk have been busy writing ‘cores’ – the name for code that adapts Arduino code to run on different hardware – for several other bare chips, and some have 20 pins – plenty. Have ...