Toshiba’s Hall sensorless sine-wave drive three-phase brushless DC motor control pre-driver IC helps reduce vibration and noise of high-speed motors.

This means you can’t control the spindle speed with LinuxCNC or Mach3. For his Hackaday Prize entry, [SUF] is building a DC motor controller for a Chinese spindle motor that doesn’t use any ...

Brushless DC (BLDC) motors are standard fare in low-precision, speedy RC applications. The control schemes needed to run them slowly or precisely go deep into motor theory and might put these motor… ...

An Arduino-based cnc controller for separate stepper drivers? grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board.

Containing two high-side and two low-side drivers, the device can control a single H-bridge powering one bidirectional DC motor or two half-bridges for two unidirectional motors.

Sponsored by Texas Instruments: With the driver ICs available today, brushed DC motor control is a snap to integrate in building-, home-, and industrial-automation applications. Motors are ...

Renesas simplifies safe, power-efficient sensor-less BLDC motor control design for industrial and home appliances with new system-in-package solutions ...

Clicker 4 Inverter Shield clips underneath the processor board and has six mosfets to mediate power between an external 12 to 48V supply and the motor, and a TI DRV8323 gate driver. An on-board ...