This project uses an Arduino to interface with an NFC reader and a servo motor. The setup allows for controlling the servo based on NFC card authentication and a physical button press. - zan08-01V/ ...

I was bored over winter break and had these parts laying around... so I built her a "Button Box" based around an Arduino. Open source, hackable, and made by hand.

On the breadboard I installed the one push button left legs at column 55 on the second part of the breadboard, rows F, G, H, I, and J. The right legs in column 53. The 330 Ohm resistor left leg into ...

The Arduino Esplora is a ready-to-use, easy-to-hold controller that lets you explore the infinite possibilities you have in the world of Arduino, without having to deal with breadboards or soldering.

Here’s a no-PCB Arduino that doesn’t obscure the DIP footprint of the AVR chip. It’s built on an ATmega88 chip, and includes a programming header, reset button, a couple of filter… ...

You can read the state of a button using Arduino and a few lines of code. The actual state is shown in the Serial Monitor window as 0 or 1, 0 meaning the button is not pressed and 1 that the button is ...

STEMTera Breadboard is specifically designed to solve common issues using Arduino with a breadboard especially in the lab or classroom. There were 3 main objectives I wanted to focus on when ...

Instructables member Qttting_F has published a fantastic project detailing how to build a Water Surface Lamp, using a little Arduino coding and hardware, ...

The Arduino Yun WiFi microcontroller board has been redesigned in a more compact housing so that it can be used with a breadboard. This is said to make prototyping easier.