TMC2208 Pinout Being a beginner, the 16 pins of this module might look complex, but believe me, it's simple to understand and use. Below, you can see the pinout marking of the TMC2208 stepper driver ...

Here is a tested Arduino project that uses 3 sensor probes as water level indicator with 3 leds and one LCD display + a simple controller that turns on a motor when the water has reached the desired ...

Keep going until you feel the wire cannot be pulled out. Repeat for A-, B+, and B-, pushing the corresponding motor wire into the terminal block hole and tightening it in place with the screwdriver ...

This example demonstrates the pins used to control all three stepper motors. A sample code snippet is provided to control the X-axis stepper motor. The Makerbase MKS DLC32 v2.1 uses an onboard 74HC595 ...

Building a 3D Scanner June 10, 2013 Building a Simple Underwater Glider Submersible This underwater glider submersible is made from a water bottle, an Arduino, a servo motor, and a syringe.