29 thoughts on “ Arduino Electronic Speed Control Explained ” minipimmer says: November 26, 2010 at 2:16 pm Very cool project. I was ...

This project implements a joystick controlled robot using an Arduino Mega 2560. The robot has two DC motors with encoders, and a joystick to control its speed and direction. The speed of the motors is ...

How to Use L298N Motor Driver Module. We can use the L298N module in two ways, either by using a Microcontroller like Arduino to control the L298N or standalone without using a microcontroller. In ...

In our case fanSpeed will have a value of 32 at tempMin and 255 at tempMax. These values are used to control the speed of the fan using PWM and the analogWrite(). The fanLCD re-maps the temp to allow ...

We set the potentiometer pin as 0 (A0 on the Arduino Uno board), the CONTROL variable is the voltage that is used to cotrol the led brightness of the speed of the fan. In the setup() function the ...

Road safety is a concern of all authorities. One of the most important safety concerns is excessive speed which results in accidents, injuries, death, as well as damage in public property. Therefore, ...

DIY Arduino High Speed Photography DSLR Trigger. 4:35 pm November 10, 2010 By Julian Horsey. ... If you’re not sure what an Arduino controller is: ...

Arduino Electronic Speed Control Explained November 26, 2010 by Mike Szczys 29 Comments You can salvage some nice motors out of optical drives but they can be tricky to control.