Arduino-Based-Underground-Cable-Fault-Locator-System Underground cable faults disrupt power & communication. This project tackles this with an Arduino-based fault locator system. A sensor cable with ...

To test it out, you do not need Arduino. Connect the Signal & Ground pin of the EMG Sensor to a Multimeter set to DC Voltage Measurement. First measure the voltage without connecting the electrodes, ...

After some searching, I ended up using a microcontroller and a piece of code borrowed from the web that I tweaked and adapted. The microcontroller-based concept was chosen because I wanted to scale ...

Abstract: This project uses an Arduino microcontroller to find and locate internal cable line faults. In many environments, electrical cables are buried rather than overhead, making it difficult to ...

The device includes the connection between an Arduino microcontroller and an optical mouse sensor to provide help in reading the movements from horizontal and vertical directions. The Arduino board ...

Testing the E18-D80NK IR Sensor Once your code and hardware are ready, connect Arduino to the laptop and upload the code. After that open the serial monitor at a baud rate of 9600, and make some ...

This is a simple arduino project for a soil moisture sensor that will light up a LED at a certain moisture level. It uses Arduino Duemilanove microcontroller board. Two wires placed in the soil pot ...

If you have an Arduino that can act as a keyboard for a PC, the code almost writes itself. [Rootsaid] uses a specific library for the PAJ7620 and another — Nicohood — for sending media keys.

Step 3: Making the Circuit Now, as we know how the components work, let’s go ahead and assemble theses components together and make a circuit as shown below. The Ultrasonic sensor is powered by 5V ...