Mount this piece on top and with this we have done building our Robotic Arm. With this, our basic robotic arm design got completed and that's how we have built our low cost robotic arm. Now connect ...

Now I mount the bending arm on the shaft of stepper motor, and next I mount the wire guider on the feeder stepper motor mount. At last I mount a roller bearing to hold the roll of wire, then PCB is ...

Drill the holes in the arduino mounting area in the case and screw the arduino in. Glue ultrasonic sensor (HC-SR04) upside down on the sensor mount above the arduino case. To mount Arduino to wall on ...

4. Connect the breadboard rails to Arduino GND and +5V, and then check that your setup matches that of Figure 10-3. Mounting the Laser. For this project, I’ve attached the servos to a pan-and ...

Circuit Diagram. Circuit Diagram for Solenoid Door Lock using Arduino is given below. Connections between Arduino and RFID are given in the table below. The positive pin of the buzzer is connected to ...

The purpose of this project is to present an alternative for the Arduino boards programming through a ladder diagram development environment. Similarly, it seeks to provide a new option for both ...