Here is an artistic Arduino project for the fun-minded. The circuit is an Arduino RGB LED controller running on a sweet ‘n’ simple code,but with a little hardware surprise outside the Arduino board.

Adafruit 5×8 WS2812 LED NeoPixel Shield for Arduino; Addressable RGB 30-LED Strip, 5V, 1m (High-Speed TM1804) Addressable RGB 60-LED Strip, 5V, 2m (High-Speed TM1804) Addressable RGB 150-LED Strip, 5V ...

The RGB LED color will change based on the distance between index and thumb that I set up on the code as fixed values. You can adjust these for your applications. The python code will send ARRAYS via ...

The circuit is simple. Point the “-” pin on the RGB LED module to the Arduino’s GND pin. If you align it right, the other three pins should enter pins 13, 12, and 11. Making It Work. Once you’ve ...

WS2811 LED Driver Pinout. GND This pin connects to the ground (GND) or 0V reference of the power supply.. DATA This pin is the data input for the WS2811 driver. It receives the control data from the ...

Circuit diagram of the RGB colour code generator is shown in Fig. 1. It is built around Arduino Uno board (Board1), 16×2 LCD (LCD1), RGB LED (RGB1) and a few other components. Fig. 1: Circuit of the ...

That will further changes the intensity of red, green and blue color in RGB LED, and different colors will be produced. Below table shows the color combinations with respective change in duty cycles.

Arduino Uno RGB LED Resistor 10K ohm Resistor 221 ohm Jumper wires ... Serial.print(blueVal/4); //Print the RGB Code, resuable in any RGB application Serial.println(")"); delay(50); } else ... the RGB ...

We can display primary colors and also generate specific colors by modifying the Arduino code. The project demonstrates the basic interfacing of TCS3200 sensor, Arduino Uno and common-cathode RGB LED.

Arduino Uno RGB LED Resistor 10K ohm Resistor 221 ohm Jumper wires Pushbutton switch Breadboard Rotary potentiometer. Procedure: You have to wire the schematic as shown in the diagram. Wire the RGB ...