Arduino has shrunk the UNO R4 with the Arduino Nano R4 board equipped with the same 48 MHz Renesas RA4M1 32-bit Arm ...

In addition to this document, the Portenta GPIO library package contains the following: The lib/python/ subdirectory contains the Python modules that implement all library functionality. The gpio.py ...

30 thoughts on “ Retro-fit Old Radio With Arduino And FM Module ” Galane says: July 2, 2015 at 1:09 am Where’s the Ard… oh, right. Report comment. Reply. lwatcdr says: ...

Arduino Nicla Sense Env is a new sensor module with temperature, humidity, and gas (TVOC, NO2, O3) ... holes and castellated pins with 1x I2C bus (shared with ESLOV connector), 1x serial port, 1x SPI, ...

Shown below is the basic hardware setup diagram. Here, Arduino’s (Uno R3) A4 (SDA) and A5 (SCK/SCL) pins are used for the I2C control, and the module is 3.3 V powered by the Arduino itself. It seems ...

The hardware is consists of an Arduino microcontroller (here an Arduino Uno R3) and a pre-wired soil moisture sensor module. The soil moisture sensor module , built around the LM393 comparator, gives ...

The usual method is to use the Arduino’s analog pins to send PWM signals to the module. This lets you mix each color, giving you full control over the RGB LED. Meanwhile, the other (digital) option is ...

The module configuration is pretty straightforward. There are 27 GPIO pins on newer Raspberry Pi, so for each GPIO pin there are these configuration options: Use GPIO pin - the most important checkbox ...

Two years after launching the Curie-powered Arduino 101 maker board, Intel is calling it quits on the hardware. The chipmaker has announced the end-of-life for its Curie Module, which launched in ...