Hi Marco & all, at the begining it was only for my own use, but no problem at all for sharing my ugly & badly commented code :) Project using Wemos D1, DS18b20 & 4.3′ epaper display from ...

The finished circuit can display numbers ranging from 0 through 1023, in connection with a 10K preset pot attached to the analog input A0 of the Arduino board. This 4 -digit 7-segment display section ...

If you’ve been pining for a retro-chic 16×2 LCD display to enhance your Windows computing experience, then [mircemk] has got you covered with their neat Windows-based LCD Info Panel. You… ...

For testing purpose only one 330 Ohm resistor (R2) is added between ground rail (0V) and the common cathode pins (3 & 8). It is better to directly connect pins 3 & 8 of the display to ground rail.

I like this project - a random name generator display. Okay it's conceptually simple and has probably been done a few times before, but it has wide application... In this lockdown learning age, the ...

All you need is an Arduino, a motion sensor, a few wires and headers, and the code provided at the site below. Hit the link to see step-by-step instructions on how to put it together.

Arduino enthusiasts and makers in search of a new project to keep them busy, might be interested in this awesome split flap display that has been created by Instructables member JON-A-TRON.

The combination of a transparent OLED display, Arduino Nano Every microcontroller, HC-05 Bluetooth module, and a small LiPo battery results in a functional and versatile piece of wearable technology.

The Giga Display Shield (plug-in board) might fit the bill. It adds a 3.97inch 480 x 800 RGB touchscreen, digital microphone (MP34DT06JTR by ST), six-axis IMU (Bosch BMI270 inertial measurement unit), ...